Help for a minisatip newbie.

Support forum for minisatip
Post Reply
Antoine3_dupres
Posts: 5
Joined: Mon Jul 31, 2017 4:47 pm

Help for a minisatip newbie.

Post by Antoine3_dupres »

I have a tvheadend with tbs5927 working fine on ubuntu 17.04.
I would like to connect the vuduo2 dvbs2 tuners to tvheadend.
I copied the gigablue minisatip to the vu duo2 and run it without parameters.
Tvheadend can see the 2 tuners.

When I start scaning from tvheadend, tvheadend find some services, but not on all frequencies (in fact only very few of them). For the one found, I cannot even see the picture from dvheadend!

My duo2 has 2 tuners as follow:
- 1st tuner: disecq a/b
-2nd tuner: disecq a/b/c/d

I stopped enigma2 before running minisatip to ensure the tuners are free.

I am wondering if I need to run minisatip with some parameters to make my config working better?
What would be the key parameters to set? (to share both tuners, there as so many parameters that I am a bit lost)

Thank you.
cata
Site Admin
Posts: 768
Joined: Tue May 12, 2015 1:01 am

Re: Help for a minisatip newbie.

Post by cata »

If your diseqc switch is 1.0, then you do not need to use any parameters in minisatip (by default). You can configure the sources in tvheadend.

If you have a specific frequency where the channels are not found you can run minisatip with:

-l http

and then upload /tmp/minisatip.log here
Let me also know the frequency where you do not find channels.

Thanks
Post Reply