Diseqc 12 ports

Support forum for minisatip
cata
Site Admin
Posts: 768
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata »

Which errors are you referring to?
Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot »

Image
Signal 80% on the receiver works fine but when watching any channel through minisatip like this
cata
Site Admin
Posts: 768
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata »

Could you try if you have the same issue with openatv?
Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot »

Unfortunately not. I have installed special openpli 5.0 with support for CI+, I use two modules so the presence of CI+ is extremely important
. On any other firmware only CI. I tried a lot
Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot »

So how can I solve my problem?
cata
Site Admin
Posts: 768
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata »

Can you offer remote access?
Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot »

Yes, i send pm you
schnuepfli
Posts: 4
Joined: Mon Jul 01, 2019 10:15 am

Re: Diseqc 12 ports

Post by schnuepfli »

Hi there

I use a dreambox with diseqc 1.1. But i can not connect to uncommited switch output 2. I start the minisat ip server with the option -d *:0-1.
Screenshot_20190725_154037.png
Screenshot_20190725_154037.png (34.1 KiB) Viewed 7855 times

Any Ideas?

Regards
cata
Site Admin
Posts: 768
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata »

If you have both commited and uncommited then you should use -d *:1-2

In this case the adapter is decided like this:

if (uncommitted_no > 0 && committed_no > 0) // Diseqc 1.0 and 1.1 enabled.
{
posc = pos % 4;
posu = pos / 4;
}

Where pos = src - 1
Post Reply