Diseqc 12 ports

Support forum for minisatip
cata
Site Admin
Posts: 568
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata » Sat Sep 16, 2017 9:57 am

Which errors are you referring to?

Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot » Sat Sep 16, 2017 12:10 pm

Image
Signal 80% on the receiver works fine but when watching any channel through minisatip like this

cata
Site Admin
Posts: 568
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata » Sun Sep 17, 2017 1:02 pm

Could you try if you have the same issue with openatv?

Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot » Sun Sep 17, 2017 2:18 pm

Unfortunately not. I have installed special openpli 5.0 with support for CI+, I use two modules so the presence of CI+ is extremely important
. On any other firmware only CI. I tried a lot

Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot » Thu Sep 21, 2017 11:46 am

So how can I solve my problem?

cata
Site Admin
Posts: 568
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata » Thu Sep 21, 2017 12:04 pm

Can you offer remote access?

Shprot
Posts: 11
Joined: Wed Sep 13, 2017 4:45 pm

Re: Diseqc 12 ports

Post by Shprot » Thu Sep 21, 2017 12:17 pm

Yes, i send pm you

schnuepfli
Posts: 4
Joined: Mon Jul 01, 2019 10:15 am

Re: Diseqc 12 ports

Post by schnuepfli » Thu Jul 25, 2019 1:42 pm

Hi there

I use a dreambox with diseqc 1.1. But i can not connect to uncommited switch output 2. I start the minisat ip server with the option -d *:0-1.
Screenshot_20190725_154037.png
Screenshot_20190725_154037.png (34.1 KiB) Viewed 1622 times

Any Ideas?

Regards

cata
Site Admin
Posts: 568
Joined: Tue May 12, 2015 1:01 am

Re: Diseqc 12 ports

Post by cata » Sun Aug 18, 2019 4:15 pm

If you have both commited and uncommited then you should use -d *:1-2

In this case the adapter is decided like this:

if (uncommitted_no > 0 && committed_no > 0) // Diseqc 1.0 and 1.1 enabled.
{
posc = pos % 4;
posu = pos / 4;
}

Where pos = src - 1

Post Reply