Page 1 of 1
Digibit R1 and oscam descrambling?
Posted: Thu Jan 18, 2018 8:57 pm
by seal
It is possible to descramble streams on Digibit R1 and pass stream desclambred to tv for example?
Im using this firmware:
https://github.com/perexg/satip-axe/tree/master/dist
i tried to this on other sh4 box (nbox) but was not stable.
Re: Digibit R1 and oscam descrambling?
Posted: Thu Jan 18, 2018 10:33 pm
by 9000h
Hi,
did you adjust the network stack for streaming like
https://github.com/perexg/satip-axe/iss ... -356834623 ?
CU
9000h
Re: Digibit R1 and oscam descrambling?
Posted: Fri Jan 19, 2018 5:54 am
by cata
Hi,
minisatip from satip-axe has the decryption part completely disabled. You can compile it in, but it will take a small toll on the performance.
Thanks
Re: Digibit R1 and oscam descrambling?
Posted: Fri Jan 19, 2018 8:39 am
by seal
9000h: i didnt adjusted yet.
cata: i saw that minisatip7 on satip-axe not descrambling - i tried to use newest binary from sh4 but i don't know if this should be used the same as on classic sh4 stb? With oscam via camd.socket? Maybe i can cacscade and move descrambling to other host:
minisat7 (satip-axe firmware) - minisat -s minisat7_ip (on linux box for example with -O to oscam) - and to this minisat i will connect TV - this will work?
Re: Digibit R1 and oscam descrambling?
Posted: Sun Jan 21, 2018 5:24 am
by cata
Hi seal,
minisatip7 on axe is not compiled with oscam support. Yes, using from another box and running:
./minisatip -s minisatip7_ip would work, but you may need to use -s parameter 4 times if you have 4 tuners.
The binary from the forum is not for axe, but for sh4 boxes running enigma (I tested it on openatv).
Thanks
Re: Digibit R1 and oscam descrambling?
Posted: Fri May 04, 2018 6:38 am
by zorrua
Hello,
Last minisatip for axe has OSCam installed and activated by default:
Could we add some cccam or newcamd lines there and descrambe the streams?
It would be great to have unencrypted channels.
Kind regards.
Re: Digibit R1 and oscam descrambling?
Posted: Sat May 05, 2018 5:48 pm
by cata
I think you can edit the oscam configuration and add your own lines