Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1

Support forum for minisatip
Post Reply
bolzerrr
Posts: 1
Joined: Mon May 28, 2018 5:46 am

Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1

Post by bolzerrr »

Hello,

i´d like to run a minisatip server on my local network using following components: Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1
I attached 2 lines from the multiswitch: H/L and V/L
I see the devices in the webinterface but i dont get a signal. Do i need further configuration? Currently i start with: -a 2:0:0 -d -e 0-1,0,0

Thanks in advance
localhosthack0r
Posts: 8
Joined: Sat Jun 24, 2017 1:17 pm

Re: Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1

Post by localhosthack0r »

You have connected the Cine S2 to the loopthrough outputs H/L and V/L ?
I think that cannot work. The loopthrough outputs are for connecting another multiswitch.

Outputs of you multiswitch for use at TVCard, TV or set top box are "Legacy Out" and "Unicable Out".
I guess you want to use Unicable. Connect this output to your Cine. One cable is enough. Then use '-u" option of minisatip.

Edit: I saw you have also a thread at mld board with similar questions. You basically got the same answers there, so why asking here again?
Post Reply