Hello,
i´d like to run a minisatip server on my local network using following components: Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1
I attached 2 lines from the multiswitch: H/L and V/L
I see the devices in the webinterface but i dont get a signal. Do i need further configuration? Currently i start with: -a 2:0:0 -d -e 0-1,0,0
Thanks in advance
Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1
-
- Posts: 8
- Joined: Sat Jun 24, 2017 1:17 pm
Re: Minisatip - DD Cine S2 - Multiswitch Inverto IDLP-UST111-CUO1
You have connected the Cine S2 to the loopthrough outputs H/L and V/L ?
I think that cannot work. The loopthrough outputs are for connecting another multiswitch.
Outputs of you multiswitch for use at TVCard, TV or set top box are "Legacy Out" and "Unicable Out".
I guess you want to use Unicable. Connect this output to your Cine. One cable is enough. Then use '-u" option of minisatip.
Edit: I saw you have also a thread at mld board with similar questions. You basically got the same answers there, so why asking here again?
I think that cannot work. The loopthrough outputs are for connecting another multiswitch.
Outputs of you multiswitch for use at TVCard, TV or set top box are "Legacy Out" and "Unicable Out".
I guess you want to use Unicable. Connect this output to your Cine. One cable is enough. Then use '-u" option of minisatip.
Edit: I saw you have also a thread at mld board with similar questions. You basically got the same answers there, so why asking here again?