Digibit R1 + Kathrein Unicable UAS481 + perexg/satip-axe
Posted: Thu Nov 01, 2018 11:32 am
Hi,
I‘m using the latest perexg/satit-axe firmware (satip-axe-201810211549-15) for the Digibit R1. It works great with a standard Kathrein LNB. However, I like to get the UAS481 running on the first input F-connector. No other LNBs are connected to the Digibit R1.
Kathrein wideband Unicable UAS481 LNB specs:
Input frequency: 10700 – 12750 MHz
Supply voltage LNB (input): 11.5-19 (power supply: 11.5-14: control: 16-19 & DiSEqC acc. To EN 50494:2006)
ID1 (SCR0): 1400 MHz
ID2 (SCR1): 1516 MHz
ID3 (SCR2): 1632 MHz
ID4 (SCR3): 1748 MHz
LOF: 10200 MHz (for low- and high-band)
My last satip-axe configure attempt:
# minisatip 0.8
MINISATIP8_OPTS=”-L *:10200-10200-10200 -u 0:1-1400,1:0-1516,2:2-1632,3:3-1748”
I think the -L option does not work in satip-axe. However, I could be wrong.
Please, give me some hints to get the UAS481 working.
Thank you all
I‘m using the latest perexg/satit-axe firmware (satip-axe-201810211549-15) for the Digibit R1. It works great with a standard Kathrein LNB. However, I like to get the UAS481 running on the first input F-connector. No other LNBs are connected to the Digibit R1.
Kathrein wideband Unicable UAS481 LNB specs:
Input frequency: 10700 – 12750 MHz
Supply voltage LNB (input): 11.5-19 (power supply: 11.5-14: control: 16-19 & DiSEqC acc. To EN 50494:2006)
ID1 (SCR0): 1400 MHz
ID2 (SCR1): 1516 MHz
ID3 (SCR2): 1632 MHz
ID4 (SCR3): 1748 MHz
LOF: 10200 MHz (for low- and high-band)
My last satip-axe configure attempt:
# minisatip 0.8
MINISATIP8_OPTS=”-L *:10200-10200-10200 -u 0:1-1400,1:0-1516,2:2-1632,3:3-1748”
I think the -L option does not work in satip-axe. However, I could be wrong.
Please, give me some hints to get the UAS481 working.
Thank you all