Options for Quad LNBs with Diseqc

Support forum for minisatip
Post Reply
esco
Posts: 2
Joined: Mon Nov 30, 2020 9:06 am

Options for Quad LNBs with Diseqc

Post by esco »

Hello,

I have Digbit-R1 with satip-axe firmware installed (version 16) and I am not able to get signal / tune muxes on tuners 3 and 4, only tuners 1 and 2 work fine.

Setup:
One dish
4x Quad LNB connected via 4x Diseqc switches to LNB inputs 1,2,3 and 4 on Digibit. Positions are 13E 19.2E 23E 1W, same cable setup (positions) for each Diseqc switch.
4x Tvheadend 4.3 running on Coreelec, all the networks are correctly added and assigned, User1 has enabled Tuner1 only, User2 has enabled Tuner2 only and so on


Strange is when User1/Tuner1 is watching TV User3/Tuner3 is able to watch channels on the same transponder but not able to scan/tune any other transponder regardless the satellite position.

I'm really confused now, do I need to add any additional parameter for minisat? I had to add "-diseqc-timing *:250-54-15-15-15-0" before because without this parameter I was not able to scan/tune Astra 19.2E on tuner1 and 2, 13E/23E/1W were fine.

Thank you.
Post Reply