Diseqc 12 ports
Re: Diseqc 12 ports
Which errors are you referring to?
Re: Diseqc 12 ports
Signal 80% on the receiver works fine but when watching any channel through minisatip like this
Re: Diseqc 12 ports
Could you try if you have the same issue with openatv?
Re: Diseqc 12 ports
Unfortunately not. I have installed special openpli 5.0 with support for CI+, I use two modules so the presence of CI+ is extremely important
. On any other firmware only CI. I tried a lot
. On any other firmware only CI. I tried a lot
Re: Diseqc 12 ports
So how can I solve my problem?
Re: Diseqc 12 ports
Can you offer remote access?
-
- Posts: 4
- Joined: Mon Jul 01, 2019 10:15 am
Re: Diseqc 12 ports
Hi there
I use a dreambox with diseqc 1.1. But i can not connect to uncommited switch output 2. I start the minisat ip server with the option -d *:0-1.
Any Ideas?
Regards
I use a dreambox with diseqc 1.1. But i can not connect to uncommited switch output 2. I start the minisat ip server with the option -d *:0-1.
Any Ideas?
Regards
Re: Diseqc 12 ports
If you have both commited and uncommited then you should use -d *:1-2
In this case the adapter is decided like this:
if (uncommitted_no > 0 && committed_no > 0) // Diseqc 1.0 and 1.1 enabled.
{
posc = pos % 4;
posu = pos / 4;
}
Where pos = src - 1
In this case the adapter is decided like this:
if (uncommitted_no > 0 && committed_no > 0) // Diseqc 1.0 and 1.1 enabled.
{
posc = pos % 4;
posu = pos / 4;
}
Where pos = src - 1