Hi,
I‘m using the latest perexg/satit-axe firmware (satip-axe-201810211549-15) for the Digibit R1. It works great with a standard Kathrein LNB. However, I like to get the UAS481 running on the first input F-connector. No other LNBs are connected to the Digibit R1.
Kathrein wideband Unicable UAS481 LNB specs:
Input frequency: 10700 – 12750 MHz
Supply voltage LNB (input): 11.5-19 (power supply: 11.5-14: control: 16-19 & DiSEqC acc. To EN 50494:2006)
ID1 (SCR0): 1400 MHz
ID2 (SCR1): 1516 MHz
ID3 (SCR2): 1632 MHz
ID4 (SCR3): 1748 MHz
LOF: 10200 MHz (for low- and high-band)
My last satip-axe configure attempt:
# minisatip 0.8
MINISATIP8_OPTS=”-L *:10200-10200-10200 -u 0:1-1400,1:0-1516,2:2-1632,3:3-1748”
I think the -L option does not work in satip-axe. However, I could be wrong.
Please, give me some hints to get the UAS481 working.
Thank you all
Digibit R1 + Kathrein Unicable UAS481 + perexg/satip-axe
Re: Digibit R1 + Kathrein Unicable UAS481 + perexg/satip-axe
Hi,
Could you provide the logs ?
./minisatip -f -l http,dvb
Thank you
Could you provide the logs ?
./minisatip -f -l http,dvb
Thank you
Re: Digibit R1 + Kathrein Unicable UAS481 + perexg/satip-axe
Hi,
I like to report back to you. It is working now. There was a temporary short in the F-connector of the potential equalizing rail. For some strange reason the other tested LMB's were not affected by this. The sat-axe configuration should be for the Kathrein UAS 481 LNB:
minisatip8 with ”-L *:10200-10200-10200 -u 0:0-1400,1:1-1516,2:2-1632,3:3-1748”
The tip came from Mr. Perexg (perexg/satip-axe) himself, and the LNB works now without any issues.
Thank you for your help and have a great day
I like to report back to you. It is working now. There was a temporary short in the F-connector of the potential equalizing rail. For some strange reason the other tested LMB's were not affected by this. The sat-axe configuration should be for the Kathrein UAS 481 LNB:
minisatip8 with ”-L *:10200-10200-10200 -u 0:0-1400,1:1-1516,2:2-1632,3:3-1748”
The tip came from Mr. Perexg (perexg/satip-axe) himself, and the LNB works now without any issues.
Thank you for your help and have a great day