Hi,
I installed a minisatip on Raspberrypi Zero W (Raspbian Stretch) and connected the Realtek RTL2832 DVB-T tuner to it.
Panasonic TV CX750 working as SAT> IP client always shows "Signal quality = 10%" and "Signal strength = 0%" regardless of the antenna settings and the selected mux/channel.
Is this a tuner problem or something else?
[Raspberrypi+RTL2832] Signal quality on Panasonic TV
[Raspberrypi+RTL2832] Signal quality on Panasonic TV
- Attachments
-
- minisatip.zip
- minisatip.log
- (93.66 KiB) Downloaded 312 times
Re: [Raspberrypi+RTL2832] Signal quality on Panasonic TV
it seems the value that was read from the driver is too small for SNR. If you think the value returned is actually real, you can use: -M *:1-16.
But I see regardless of the signal you do have data.
But I see regardless of the signal you do have data.
Re: [Raspberrypi+RTL2832] Signal quality on Panasonic TV
I think the signal strength value returned from the driver is not real.
ProgDVB also show incorrect strength and quality of the signal.
Adding the -M *: 1 to 16 parameter doesn't change anything.
Is there any Realtek RTL2832 driver for Raspbian that returns correct signal values?
ProgDVB also show incorrect strength and quality of the signal.
Adding the -M *: 1 to 16 parameter doesn't change anything.
Is there any Realtek RTL2832 driver for Raspbian that returns correct signal values?
- Attachments
-
- STR SNR level
- Signal STR SNR.jpg (100.68 KiB) Viewed 4774 times
Re: [Raspberrypi+RTL2832] Signal quality on Panasonic TV
Can you try a newer kernel ? I see it is using the old api, maybe the new api wouls work better?