Hi cata!
First of all my apologize for the delay to answer you. I´ve been very busy in my work and after that I´ve taked my
vacations without possibility to test anything and being outside my home.
I´m back at home again and I´ve started to try your satip version that you provide. As @localhosthack0r pointed the
correct path is /sbin/minisatip7 so, these are the actions done:
First of all I must say that because your file was named as minisatip I´ve renamed as minisatip7 before to be transfered
to the digibit using WinSCP.
1) mv /sbin/minisatip7 /sbin/minisatip7.orig
2) WinSCP: Transfer your new minisatip7 file to the path /sbin/minisatip7
3) cd /sbin/
4) chmod 777 minisatip7
The settings in the file /etc/sysconfig/config are the same:
# minisatip 0.7
#
MINISATIP7="yes"
MINISATIP7_OPTS="-7 0:1,0:2,0:3 -L *:9750-10600-12000"
Exit from putty session and reboot the Digibit
Trying to tune the frequency 11973V from tvheadend... below you can find the log:
https://pastebin.com/raw/iitWvH5k
As I said before with my STB (sat receiver) connected in the same wall conector is able to tune that frequencies. I´ve taked some pictures of how is configured.
I can tune channels from 11973V and watch them without problems in my reciever.
Even, I can reach to tune frequencies till 11856V with a good signal.
NOTE: After write this message I´ve seen the limitation of 1 link on each post so I will write this message in the GitHub thread to include the pictures and show also to perexg.
Is there any kind of configuration in the satip to be able to recieve all the channels in the same way like a reciever is connected straight to a sat dish?
Because in that way, all frequencies Low and High should be recieved, not?
Thank you very much